x

Warren Rockmacher

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 15, 2017 at 5:25 pm in reply to: Question about PROPER set up from mixer to amp #2541191
    Warren Rockmacher
    Participant

    I am looking for a way to get a line level signal from the iPhone, iPad, or pc to my mixer and amp. I hope that clears it up.

    March 15, 2017 at 5:23 pm in reply to: Question about PROPER set up from mixer to amp #2541181
    Warren Rockmacher
    Participant

    Dj Vintage – Thanks for the information. I still would like to know if there is a “device” or if someone has a better setup than just running an audio cable from an iPhone or iPad that will allow “line out” audio which will then be amplified by the system. Maybe I am a little confused -in the terminology – but I look at it like amplifying a signal coming out of an amp. I know that there is a big difference between the two because the iPhone isn’t really amplifying the signal. I think it would be the same setup as a pc – you are using a headphone jack with volume control on the pc. Therefore the pc is sending out an amplified signal to the amp. Hope this makes sense.

    March 14, 2017 at 9:51 pm in reply to: Question about PROPER set up from mixer to amp #2540741
    Warren Rockmacher
    Participant

    Thanks – I have no idea what “Noise Floor” is. On the older iPhones you could plug an adapter into the 30 pin port and get “line out” un-amplified audio, which was perfect. iPhone 7 – with new type of “jack” You cant do that anymore. I guess the Same Holds true of you run audio out from a p.c. or mac from the headphone jack. No “line out” setting, so Volume all the way up?

    Thanks!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)