x

Danny P

Forum Replies Created

Viewing 6 posts - 31 through 36 (of 36 total)
1 2 3
  • Author
    Posts
  • February 23, 2015 at 7:07 pm in reply to: Portable DJ Controllers to work with Serato #2145791
    Danny P
    Participant

    The Gemini Slate that was in a recent video that Phil did works with Serato and seems rather compact.

    February 23, 2015 at 7:05 pm in reply to: "It's too loud can you turn it down" vs "turn it up" #2145781
    Danny P
    Participant

    I usually err on the side of keeping the volume lower, especially since it’s a wedding and not a rave. In the beginning I’ll leave the base down a bit to allow for conversation and put it back to 12 o’clock when the dancing is about to start. As the night goes on the older ones will leave and the volumes go up. I always have a lot of headroom though and I have been complimented on my volume levels.

    February 4, 2015 at 2:06 pm in reply to: PA system setup #2135231
    Danny P
    Participant

    I enjoy using my 2 behringer 15″s. The sound quality and output power are adequate for me. The weight especially is good for me. But that’s just my 2 cents.

    January 27, 2015 at 4:19 am in reply to: Key detection VirtualDJ8 vs KeyFinder 1.25 #2130531
    Danny P
    Participant

    I have noticed that they have improved the Key detection between VDJ 7 and VDJ 8 as now VDJ 8 corrects someof the keys from VDJ 7.

    January 27, 2015 at 4:14 am in reply to: VDJ8 Scratch settings #2130521
    Danny P
    Participant

    While I’m in no way an expert and do not have that particular controller, some suggestions i have would be going into the advanced settings and adjusting the jogsensitivity and setting scratch delay to 0. you can also adjust the crossfader curve to scratch. I have the different curve settings set to keyboard keys for convenience.

    January 27, 2015 at 4:09 am in reply to: Windows 10 Preview and Traktor. Will they play nice? #2130511
    Danny P
    Participant

    You could try doing some maintenance on your current installation. run CCleaner and check on your start-up programs and uninstall any toolbars.

  • Author
    Posts
Viewing 6 posts - 31 through 36 (of 36 total)
1 2 3